I just installed GAMI injectors. I'm in the process of tweaking them now by doing the GAMI lean test. I am wondering if the resolution of the EGT readout can be change to 1 degree from the default 5 degrees for purposes of the test. On my last GAMI lean test it seemed like a couple cylinders showed the same peak value for a fuel flow spread of about .5 g/hr. I realize that that 5 degrees resolution is probably sufficient but I figure that if it can be changed, then why not do it?

I guess if there is no way to change the default resolution I can alway interpolate to find fuel flow at the true peak.

Any suggestions on how to do this? I have RTFM but can't find anything amongst the 728 pages.

The resolution cannot be changed on the G1000.

Thanks Steve. That was my guess.