20 Jun 2025, 10:21 [ UTC - 5; DST ]
|
|
Page 1 of 1
|
[ 3 posts ] |
|
| Username Protected |
Message |
|
Username Protected
|
Post subject: FS: Hangar clean up  Posted: 22 Sep 2024, 11:31 |
|
 |
|
|
Joined: 03/24/08
Posts: 2832
Post Likes: +1116
Aircraft: Cessna 182M
|
|
|
Various EI parts:
Mux 8A, recorder for UBG-16 engine monitor, never installed, complete kit. EI shows newer version at 650. Bought to install and then never got a round tuit. $250 OBO + mail charges, will fit in priority mail small box
EI VA1-60 Volts/Amps/discharge. Removed at install of JPI 900, was working, with connector, make some offer. smile I think I have a couple of external shunts that go with this. New they are ~$450, 200 OBO + mail charges, will fit in priority mail small box
EI AL1-X annunciator light, new in bag, never installed, new they are 30, $12 + mail charges, will fit in priority mail envelope SOLD
One Fiberlite FL 318 instrument ring, 2 inch I think, with fiberoptic cable & 3 light sources, all new in bag. We had installed Fiberlites before going to G3X. All new in bag, spares from install, $10 & mail charges, will fit in priority mail small box. SOLD
One used UBG probe, pretty sure it is a P-100 CHT probe for a UBG-16. May work with newer EI systems. New is $128.00, anyone who buys the MUX gets it for ten bucks, otherwise $35 + shipping, will fit in priority mail envelope.
Can take Paypal or just send a check.
I can send pics if needed.
RAS
Last edited on 23 Sep 2024, 19:11, edited 1 time in total.
|
|
| Top |
|
|
Username Protected
|
Post subject: Re: FS: Hangar clean up Posted: 22 Sep 2024, 13:54 |
|
|
|
|
Joined: 01/18/16
Posts: 199
Post Likes: +32
Aircraft: Bellanca 260, PA 20
|
|
|
I will take the Fiberlite.
|
|
| Top |
|
|
Username Protected
|
Post subject: Re: FS: Hangar clean up Posted: 29 Sep 2024, 10:07 |
|
|
|
|
Joined: 03/24/08
Posts: 2832
Post Likes: +1116
Aircraft: Cessna 182M
|
|
|
Bump for various EI parts:
Mux 8A, recorder for UBG-16 engine monitor, never installed, complete kit. EI shows newer version at 650. Bought to install and then never got a round tuit. $250 OBO + mail charges, will fit in priority mail small box
EI VA1-60 Volts/Amps/discharge. Removed at install of JPI 900, was working, with connector, make some offer. smile I think I have a couple of external shunts that go with this. New they are ~$450, 200 OBO + mail charges, will fit in priority mail small box
One used UBG probe, pretty sure it is a P-100 CHT probe for a UBG-16. May work with newer EI systems. New is $128.00, anyone who buys the MUX gets it for ten bucks, otherwise $35 + shipping, will fit in priority mail envelope.
Can take Paypal or just send a check.
I can send pics if needed.
RAS
|
|
| Top |
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
Terms of Service | Forum FAQ | Contact Us
BeechTalk, LLC is the quintessential Beechcraft Owners & Pilots Group providing a
forum for the discussion of technical, practical, and entertaining issues relating to all Beech aircraft. These include
the Bonanza (both V-tail and straight-tail models), Baron, Debonair, Duke, Twin Bonanza, King Air, Sierra, Skipper, Sport, Sundowner,
Musketeer, Travel Air, Starship, Queen Air, BeechJet, and Premier lines of airplanes, turboprops, and turbojets.
BeechTalk, LLC is not affiliated or endorsed by the Beechcraft Corporation, its subsidiaries, or affiliates.
Beechcraft™, King Air™, and Travel Air™ are the registered trademarks of the Beechcraft Corporation.
Copyright© BeechTalk, LLC 2007-2025
|
|
|
|
