10 May 2025, 21:39 [ UTC - 5; DST ]
|
|
Page 1 of 1
|
[ 6 posts ] |
|
| Username Protected |
Message |
|
Username Protected
|
Post subject: Wanted Garmin 496 Cable  Posted: 05 Jun 2021, 08:49 |
|
 |
|
|
Joined: 11/02/12
Posts: 317
Post Likes: +93
Company: DCM Air
Aircraft: Cessna 172/T210/310
|
|
|
Anyone have a spare 496 cable or know where to get one? Looking to connect up for a autopilot installation.
_________________
Dan
AP/IA, CFII, Limited Repair Sta Lic
|
|
| Top |
|
|
Username Protected
|
Post subject: Re: Wanted Garmin 496 Cable Posted: 05 Jun 2021, 13:02 |
|
|
|
|
 |
Joined: 01/25/20
Posts: 205
Post Likes: +32
Aircraft: h35
|
|
Username Protected wrote: Anyone have a spare 496 cable or know where to get one? Looking to connect up for a autopilot installation. Pretty sure aircraft Spruce sells them for about $30. Also eBay. And even Amazon. It’s just a data power cable and should work with the 196-496 series Alt
|
|
| Top |
|
|
Username Protected
|
Post subject: Re: Wanted Garmin 496 Cable Posted: 05 Jun 2021, 16:40 |
|
|
|
|
Joined: 10/27/19
Posts: 123
Post Likes: +19
Company: MAS
Location: Twin Falls, Idaho
Aircraft: Bonanza F33A
|
|
|
Make sure you get the genuine Garmin part # 010-10513-00, with 9 leads from all 9 contacts of the connector and a fused power lead. Many of the knock-offs only have 4 wires and dont connect to all data leads. They are Ground, Power, Voice +, Voice -, Port 1 in, Port 2 in, Port 1 out, Port 2 out, and "Alarm".
I have one brand new that I never did use. Bought from the Pilot Shop on line for $32.95 plus shipping. I will sell this one for $30 shipped. PM if interested.
|
|
| Top |
|
|
Username Protected
|
Post subject: Re: Wanted Garmin 496 Cable Posted: 05 Jun 2021, 21:36 |
|
|
|
|
Joined: 11/02/12
Posts: 317
Post Likes: +93
Company: DCM Air
Aircraft: Cessna 172/T210/310
|
|
|
My connector only has 4 pins. I've owned/used 396/496's for many years and still do. I have two power plugs and was going to use but they only have 2 wires. I'm assuming the other two wires provide the signal to drive an autopilot. I will look at a friends tomorrow to verify how many wires his has as it does drive his autopilot in his RV6A.
_________________
Dan
AP/IA, CFII, Limited Repair Sta Lic
|
|
| Top |
|
|
Username Protected
|
Post subject: Re: Wanted Garmin 496 Cable Posted: 07 Jun 2021, 21:54 |
|
|
|
|
Joined: 11/02/12
Posts: 317
Post Likes: +93
Company: DCM Air
Aircraft: Cessna 172/T210/310
|
|
|
Doug is correct, 9 wires. Appreciate all the help. Thanks
_________________
Dan
AP/IA, CFII, Limited Repair Sta Lic
|
|
| Top |
|
|
|
Page 1 of 1
|
[ 6 posts ] |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
Terms of Service | Forum FAQ | Contact Us
BeechTalk, LLC is the quintessential Beechcraft Owners & Pilots Group providing a
forum for the discussion of technical, practical, and entertaining issues relating to all Beech aircraft. These include
the Bonanza (both V-tail and straight-tail models), Baron, Debonair, Duke, Twin Bonanza, King Air, Sierra, Skipper, Sport, Sundowner,
Musketeer, Travel Air, Starship, Queen Air, BeechJet, and Premier lines of airplanes, turboprops, and turbojets.
BeechTalk, LLC is not affiliated or endorsed by the Beechcraft Corporation, its subsidiaries, or affiliates.
Beechcraft™, King Air™, and Travel Air™ are the registered trademarks of the Beechcraft Corporation.
Copyright© BeechTalk, LLC 2007-2025
|
|
|
|
